Make an entry using a paper clip or the SIM eject tools in a hole inside the SIM card slot, which may be found on the phone’s power button side. Cleaning your microwave is recommended before continuing, since any unpleasant sludge on the bottom of the microwave may get attached to the opener if left there.

Silky Terrier Dog Breed Playing Aro... Silky Terrier Dog Breed Playing Around

Make a hole in the middle of the microwave using the iOpener. For thirty seconds, heat the iOpener. Keep re-heating the opener inside the microwave for 30 seconds at a time during the repair process, as even the opener cools down. The opener should be taken out of the microwave while gripping one of its two flat ends so prevent touching the heated middle. Instead of using the microwave, you may heat the iOpener into boiling water by following the steps below.

Make sure you have enough water in a saucepan or pan so that you can completely immerse an iOpener. Check to ensure that the iOpener is completely immersed in the water before continuing. To remove the heated iOpener first from hot water, use tongs to lift it from the water. Using a towel, completely dry the opener. Keep in mind that the iOpener will become very hot, so only hold it by the ends of the tabs at all times.

Your opener is now fully operational. Alternatively, you may reheat the iOpener by boiling it for 2-3 minutes, turning off from the heat, and placing it back in the water. If you open your phone, the waterproof seals will be compromised. Ensure that you have a fresh supply of replacement glue on hand before you begin, or take precautions to prevent liquid contact if you want to reassemble the phone without replacing all adhesive. Put packing tape around the whole panel if your glass has broken to keep it together while the glass is being removed.

Apply some heat to the back panel for approximately two minutes to release the glue that has formed around its edge and to make it easier to remove the panel. Depending on how cold your phone is, you may have to warm it up by reheating and applying the iOpener many times. Avoid overheating by following the opener instructions. For another two minutes, move the opener to the opposite part of the panel and heat it there as well.