Step 1: SIM Card Tray

Silky Terrier Dog Breed Playing Aro... Silky Terrier Dog Breed Playing Around

Inject a SIM tool for ejecting, SIM eject bit, or a straightened paper clip through the tiny hole inside the SIM tray high up on the handset. Press to remove the tray. This could require some effort. Get rid of the SIM tray for the SIM card.

Step 2: S-Pen

With your finger, press down on the pen button, until the phone clicks. It then appears to pop out of the phone. Take out the S-Pen.

Step 3: Rear Glass

Place the warmed iOpener to the phone’s bottom for approximately two minutes.

Step 4:

Use the suction cup as close as you can to the edge that is closest to the phone. Lift the suction cup and place an opening pick underneath the glass on the back.

Step 5:

After the pick is placed, heat the edge using an opener for a further minute.

Step 6:

Move the pick towards the bottom of the handset. Keep the pick in place to stop the adhesive from resealing and then pick another one when you move on through the steps.

Step 7:

Add another one and gradually cut around the edge of the phone.

Step 8:

Before cutting further, apply an opener that is heated to your long edges.

Step 9:

Repeat the heating and cutting process on the other three edges of the telephone. Place an opening in the edge of the phone before you go on from one edge to prevent the adhesive from sealing again.

Step 10:

Make use of an opening pick to cut off any adhesive from the glass’s edges. Lift the glass up and take it off the phone.

Step 11:

Utilize tweezers to remove any adhesive remaining from the back cover as well as the chassis of your phone. Cleanse the adhesion sites using high-concentration isopropyl alcohol and a clean cloth.

Step 12: Midframe

Get rid of the 20 3.3 millimeter Phillips screws.

Step 13:

Take out the middle frame.

Step 14: Battery

Use an opening pick to slide it under the edge at the bottom of the battery and gently lift it out of the case.

Step 15:

Then slide an opening across the battery and break it up to remove any adhesive that remains. Attach the battery to the phone using cut adhesive or double-sided tape. Place the battery in the position for 5-10 seconds.