Get the Right Honda Civic Key Fob Battery

The majority of Honda key fobs use the same flat circular 3-volt battery, which can you can get from just about any hardware store. You can also pay your Honda dealership a visit to get help with your key fob battery.

Silky Terrier Dog Breed Playing Aro... Silky Terrier Dog Breed Playing Around

Honda Civic Key Battery Replacement

When the battery for your Honda keyless remote is low, you can certainly use these steps to open and access the Honda key fob, remove/replace the battery, and also, put the key fob back to its original state. It’s everything you need to know when your Honda keyless remote battery is low:

1. To get started, you will need to slide the button that actually releases the metal key, which will allow you to and get the key out.
2. If you want, you can use a flathead screwdriver or the key to open the key fob. 
3. Use your thumb to press down right above the battery so that you can hold the fob together. I not, so the contents and external buttons will fall out, which you don’t want to happen.
4. Take out the dead battery, remember the positive and negative sides, so that you will be able to properly install the new battery. Avoid touching the terminals on the new battery. The oils from your skin can cause corrosion in the battery, which will shorten its life.
5. Be sure to put the new battery back in the same position as the previous battery. Use the positive (+) and negative (-) as a guide.
6. Put the two parts of the Honda Civic key fob together and lightly press until they snap back in place.

Note: Should your Honda key fob have a screw that actually holds the halves together instead of an actual button then, use a small flathead screwdriver to take out the screw, and then follow the steps mentioned above to change the battery.

What To Do If Your Honda Key Fob Falls Apart?

In case, internal pieces of your key fob fall out, you can use your spare key as a guide on how to put it back together again.

1. Put the buttons into the proper slots.
2. Put the crossbar right between the empty spaces of the two buttons at the top, with the crossbar’s curvature in an outward position.
3. Insert the battery right into the motherboard with the + sign facing out.
4. Put the motherboard directly into the key fob so that the rubber film is against the buttons.
5. Safely Line up the key fob back with the front. After that, press them together until you are able to hear them snap into place.
6. Get close to your car and press all of the buttons to ensure that everything is working correctly.

If you face any issues with putting your Honda key fob back together gain, then you can visit your local Honda Dealership so that you can get the help that you need.