Removal of the bracelet and case-back, i.e. Remove the band first from a case of the watch and use a spring bar tool to do so. Remove its case-back by turning it counterclockwise using a case-back removal tool, and then gently screw it back on. Use caution while working with worn-out and otherwise twisted tools, since they may cause irreparable harm to your timepiece.

Silky Terrier Dog Breed Playing Aro... Silky Terrier Dog Breed Playing Around

Removal of the battery and O-Ring, for example. After removing the case back, use a screwdriver to unscrew the tiny component that holds the battery in place, and then remove the battery. With the tweezers, gently remove the battery and also the O-Ring from the device and destroy them, or carefully examine the device for rips & tares. If you are unable to locate any, the gasket might well be re-used after being lubricated using gasket lubricant.

The Power Consumption Test, which is to say that you conduct the power consumption test here on the watch using the appropriate equipment (in this case, the Witschi Q TEST 6000), that’s what we’re talking about.

Installation of a new battery, which means getting the new battery & installing it with the tweezers. Handling a fresh power cell must only be performed using tweezers utilizing insulated tips to avoid damaging the cell. We prefer to use Energizer batteries since they have a lower likelihood of spilling potentially hazardous acid through into movement.

Ultrasonic cleaning of the case and bracelet, which means cleaning its case but also bracelet using ultrasonic but also steam equipment.

Before re-installing the case-back onto the watch case, a replacement gasket or O-Ring should be fitted, as described above. Make a clean entry for the new O-Ring into the lubrication box then close the lid to ensure that it is thoroughly coated. Once the gasket has been properly greased, gently screw the case back into place until it is secure. Maintain perfect alignment of the case-back with the case to prevent any harm from occurring. Check for a good fit by turning the case back in both the clockwise and anticlockwise directions to verify that it screws into place smoothly. Do not over-tighten the tool, even if it should be secured securely; otherwise, the tool may slide and cause a significant scratch on the case-back.