Silky Terrier Dog Breed Playing Aro... Silky Terrier Dog Breed Playing Around

Fixing low voltage, inability to charge, or power issues on your smartphone may be made easier with the help of this patch.

1. To turn off your Galaxy S8, hold down the power button until you see “Switch off.”

2. Remove the back cover’s glue with a hairdryer. You’ll use the hairdryer a lot, so don’t put it too far away. The back cover should be suction-cupped. Use a flat instrument to press between the rear glass and the frame at the same time. At this point, the heat from the hairdryer will help loosen the glue. Place a plectrum in the instrument now. You can therefore continue to use your tool because the hole is still open.

3. After loosening the back cover, remove the fingerprint sensor connector from the spudger. With everything unattached, you may now remove and discard it.

4. Use a flat tool to carefully pry the antenna off the board. The housing lid is secured using screws. The middle panel is detachable for cleaning.

5. Use a spudger to carefully pry the battery connector away from the device. Use a plastic spudger to avoid creating a short circuit.

6. The speaker can be removed by using tweezers.

7. When removing the battery, be cautious not to harm the body. Gently remove the battery by inserting your tool between the battery and the casing. On the other half of the battery, the reps are in position. Keep the main circuit board and the other components safe. Once the glue has been released, the battery can be easily removed.

8. Insert the battery into the compartment on the back of the housing. If you want to use the original sticky surfaces again, gently push the battery down on them.

9. Attach the battery to the circuit board using the battery terminals on the board. Push the connector tightly till you hear a pop. After that, the connection is permanently shut down.