The steps below will lead you through how to change the measurement unit:

Silky Terrier Dog Breed Playing Aro... Silky Terrier Dog Breed Playing Around

1. Hold and press your F2 button for approximately 6-9 seconds until the thermometer shuts off.

2. Keep pressing the button until you can see that the unit of temperature “– degC or degF” is displayed in the display.

3. Release your hold to the button F2. The temperature unit that has”-” will begin flashing “– degC or degF” will start flashing.

Click the button F2 for a second time in five seconds to set the temperature to the setting you want to use.

Be sure you have the Forehead and Ear Temperature Sensor from Innovo are in direct contact with your forehead before you utilize its forehead mode to determine your temperature. If the device isn’t directly touching the forehead, accurate measurements may not be able to be taken.

Temperatures can be measured with The Innovo Medical forehead or Ear Thermometer both in Fahrenheit or Celsius.

There’s no option to disable this sound. Moreover, there is only a single beep in length.

Make several readings, and wait at minimum 10-seconds between every reading to ensure you’re not wasting time. The thermometer is very sensitive to even tiny variations in temperature. constant use with no break between readings could produce inaccurate readings due to heat created due to friction on the surfaces that the thermometer sits on.

To access the thermometer’s readings stored in memory, follow these steps:

Hold on the button F2 for around 3 to 6 seconds or until you can see M appear on the LCD panel. “–“M show up on your LCD screen.

Press the F2 key for a second time and the screen will show “1” with the M signal, to indicate the initial recorded temperature was achieved. The temperature recorded will be displayed.

If you want to recall the previous recorded reading, press the F2 button for a second time. When you press the F2 button, the amount “2” will be shown on the M signal which indicates that the recorded reading was recalled.

Play the tape again to bring back memories from the past.

To clean the thermometer, take a cotton swab and soak it in alcohol, then wipe it over the sensor’s surface. Make sure you wait 5-10 minutes to allow that the alcohol’s vapor to fully evaporate prior to making use of the thermometer for the third time.