How do I turn on my Skytech fireplace remote?

The main gas valve should open and the main gas flame should ignite after the pilot flame has been lit. Turn the switch off by pressing the button. The main gas flame and the pilot flame must both be extinguished. Switch to ON mode by pressing MODE on your transmitter and sliding the remote control’s switch to REMOTE (the center position).

Why does my fireplace remote not work?

1) Batteries are either underpowered or incorrectly installed. 2) A lack of understanding of how the fireplace’s remote controls work. 3) The receiver’s slide switch is not properly set. The “learn” function on the receiver has not been activated on the remote hand-held transmitter.

How do I reset my Skytech fireplace?

For a clean slate, simply keep pressing and holding the “Learn” button until you hear consecutive beeps, which indicates that the memory has been cleared.

Why is my Skytech fireplace beeping?

Protecting the receiver from being damaged or melting is the purpose of this. After 130 degrees Fahrenheit is reached in the receiver case’s thermistor (thermocouple), a series of four (3) “beeps” is emitted every four seconds by the receiver, signaling the end of the fireplace system.

How does a Skytech remote work?

To turn on or off a gas-heating fireplace, the Skytech 1001 On/Off Fireplace Remote Control simply presses a button on the remote. A single 12V battery powers the remote control transmitter, which in turn controls a two-button ON/OFF system to send wireless signals to a receiver powered by four AA batteries.

How do I set the temperature on my Skytech remote?

In order to enter the room, press the • MODE button until the LCD screen displays “ROOM.” (Check out the Thermo Mode image) If desired, press and hold the • SET key to adjust the set temperature. To put it another way, the temperature ranges from 99oF to 45oF.